Instructions / Assembly

DESCRIPTION
Anvil 1220 Elastomeric Smooth Brush on
Grade SeamSeal is a heavy bodied, flexible,
elastomeric patching material for filling and
patching cracks joints and seams on; masonry,
stucco,concrete block, brick, stone, marble, wood,
metal MH roofs and glass prior to applying finish.
Anvil 1220 Elastomeric, Smooth, Brush on
Grade SeamSeal provides excellent adhesion,
long life, and is resistant to failure by expansion,
contraction, or other joint movement. Fast drying
and may be painted with latex or oil base paints.
For use on interior or exterior surfaces.
SURFACE PREPARATION
Surface must be free of dirt, oil, grease,
efflorescence, chalk, mildew, and loose material
Any residual chalk left after pressure washing
should be sealed with Anvil 230 or 231 Chalky
Surface Conditioner. New Galvanized metal
should be treated to remove mill oils. Ferrous
metal should be free from rust and primed with
Anvil 1606 Rust Inhibitive Primer Sealer.
APPLICATION
Apply with brush or roller. Apply a generous first
coat to seal entire area. For best results use
polyester membrane to reinforce repair. Work
membrane into wet sealant while smoothing to
follow the contours of the area. Apply second
coat of sealant to cover membrane and allow to
dry before applying finish coat of paint.
LIMITATION OF LIABILITY
This product is manufactured to rigid control
specifications. It is impossible to control the use
and application. Therefore, the manufacturers
sole liability is limited to replacing quantities of
product proven to be defective. The manufacturer
disclaims any liability for the cost of labor to
repaint or any other use of the product.
Page 1 of 1
TECHNICAL DATA
PRODUCT NUMBER: 1220 Elastomeric, Smooth
Brush Grade, SeamSeal Caulking Compound
RESIN: Acrylic Latex
COLOR: White
GLOSS: Flat
SOLID CONTENT:
BY WEIGHT: 81.40%
BY VOLUME: 70.85%
RECOMMENDED COVERAGE:
100 Sq. Ft./Gal.
PIGMENT BY WEIGHT: 55.04%
VEHICLE BY WEIGHT: 44.96%
VISCOSITY: 120KU
WEIGHT PER GALLON: 13.26 lbs
FLASH POINT: N/A
DRYING TIME @ 70° F. 50% R.H:
Touch - 1/2 hour
Paint over - 1 to 2 hours
Full cure - 48 hours
Do not apply when rain, cold or nightfall is
imminent. do not apply below 50 °F. Drying and
cure time are influenced by ambient temperature
and relative humidity.
THINNER/CLEANUP: Water
TINTING: Not Recommended
VOC: 45.6 grams/liter
AVAILABLE 1 & 5 GALLON PAILS
Revised 1-09 Supersedes all prior publications GRO
1220
ELASTOMERIC BRUSH GRADE
SEAMSEAL