SDS

EXTINGUISHING MEDIA
Water based coating. Will not burn under normal circumstances.
UNUSUAL FIRE AND EXPLOSION HAZARDS
Closed containers may explode when exposed to extreme heat.
SPECIAL FIRE FIGHTING PROCEDURES
Water may be used to cool to prevent pressure build up.
PERSONAL PRECAUTIONS
Avoid breathing fumes. Wear proper personal equipment.
ENVIRONMENTAL PRECAUTIONS
Do not allow to enter sewers/surface or ground water.
METHODS OF CLEAN UP
Absorb spill with vermiculite, floor absorbent or other absorbent materila.
SAFE HANDLING
Avoid breathing fvapors or spray mist.
FIRE PREVENTION
The product itself will not burn.
STORAGE
Keep container closed in a drywell ventilated place.
CHEMICAL NAME CAS # OSHA PEL ACGIH TLV WT %
TITANIUM DIOXIDE 13463-67-7 10 mg / m³ 10 mg / m³ 0.00 -16.80
ALUMINUM SILICATE 1332-58-7 NE NE 9.60
DI PROPYLENE GLYCOL MONO BUTYL ETHER 29911-28-2 NE NE 1.24
ACRYLIC POLYMER 122055-81-6 NE NE 36.60
WATER 7732-18-5 NE NE 27.70
RED IRON OXIDE 1309-37-1 NE NE 0.00 -10.00
YELLOW IRON OXIDE 51274-00-1 NE NE 0.00 -10.00
BLACK IRON OXIDE 1317-61-9 NE 5 mg / m³ 0.00 -10.00
POLYPROPYLENE 9003-07-0 NE 5 mg / m³ 0.00 - 2.00
RESPIRATORY PROTECTION
Whenever workers are in concentrations abovethe exposure limit they must use appropriate NIOSH/MSHA approved respirators.
SKIN PROTECTION
Wear impervious gloves and apron to prevent skin contact.
EYE/FACE PROTECTION
Use splash-proof safety googles or face shield.
OTHER PRECAUTIONS
Eyewash station and safety shower should be available within the workplace.
ENGINEERING CONTROLS
Local exhaust preferable. General exhaust is acceptable if maintained below applicable exposure limits.
SECTION 5 - FIRE FIGHTING MEASURES
SECTION 6 - ACCIDENTAL RELEASE MEASURES
SECTION 7 - HANDLING AND STORAGE
SECTION 8 - EXPOSURE CONTROLS / PERSONAL PROTECTION
2 of 3