User's Manual
Table Of Contents
- Chapter 1:INTRODUCTION
- Chapter 2:INDICATIONS, CONTRAINDICATIONS AND WARNINGS
- Chapter 3:WIRING AND CONTROL PANEL OF CONSOLE
- Chapter 4:OPERATION INSTRUCTION FOR ESNAVI SOFTWARE
- 4.1Installing Software
- 4.2Uninstalling Software
- 4.3Basic Operation of Software
- Chapter 5:USAGE OF CAPSULE
- Chapter 6:USAGE OF DATA RECORDER
- Chapter 7:INSTALLATION AND TRAINING
- Chapter 8:MAINTENANCE
- Chapter 9:WARNINGS, CAUTIONS AND TROUBLESHOOTING
- 9.1ESNavi Error Messages
- 9.1.1.1.1.Check if camera is connected firmly
- 9.1.1.1.2.Equipment initialization error
- 9.1.1.1.3.Port "COM7" does not exist
- 9.1.1.1.4.Video monitoring connection fails
- 9.1.1.1.5.Port "COM8" does not exist
- 9.1.1.1.6.Serial port initialization error
- 9.1.1.1.7.Port "COM4" does not exist
- 9.1.1.1.8.Cannot connect to Data Recorder
- 9.1.1.1.9.Password error
- 9.1.1.1.10."Print error" prompt box
- 9.2Problems with Translational Rotation Platform
- 9.3Problems with Capsule
- 9.4Problems with Data Recorder
- 9.5Problems with Locator
- 9.1ESNavi Error Messages
- Chapter 10:TECHNICAL SPECIFICATIONS
- Chapter 11:SYSTEM LABELING
NaviCam
®
Stomach Capsule User Manual Page | 2
AnX Robotica Corp. UM-NCES-ST-01 Rev 1
Copyright Statement:
The ownership of the User Manual belongs to AnX Robotica Corp., and it should not
be distributed or reproduced by any means or in any form without prior written
permission by AnX Robotica Corp. The User Manual is protected by copyright, and
all rights are reserved.
AnX Robotica Corp. reserves the right to change the User Manual and the products as
described herein. Equipment specifications are subject to change without prior
notification. Any information contained in the User Manual is not to be considered a
proposal, guarantee, commitment or contractual conditions.
Warranty
AnX Robotica Corp. assures that all parts in the NaviCam Capsule Endoscope System
with NaviCam Stomach Capsule are well-designed, manufactured, packed and tested
for prevention of defects, and assumes no responsibility for any accident, loss,
damage or cost increase directly or indirectly resulting from use of the ESNavi
platform. AnX Robotica Corp. will repair or replace parts within the warranty period,
while customer is responsible for all other items including normal wear and team or
anything that is out of the control of AnX Robotica Corp., including but not limited to
operation, storage, cleaning, misuse, abuse, patient treatment or diagnosis. This
warranty replaces any other warranties which may have been implied in verbal or
documented form.
Modifications by User or Third Party
Any and all modifications to the product which are not expressly in writing
approved AnX Robotica Corp. will void this warranty in its entirety.
Caution:
US Federal law restricts this device to sale by or on the order of a physician.
AnX Robotica Corp.
Address: 7213 Regency Court, Plano, TX, 75024, U.S.A
Office phone:925-202-2247 Fax: 925-201-3852
Manufacture: Ankon Technologies Co., Ltd.
Address:B3-2 Biolake, No.666, Hi-Tech Road, East Lake New Technology
Development Zone, Wuhan, 430075 Hubei, China