User manual

Supported Use Cases 20
Doc.Id. HMSI-27-205
Anybus Wireless Bridge - Ethernet to WLAN
Doc.Rev. 1.30
Alternative 2 - Manual Configuration
This example shows the settings when SMART mode 8 (Wireless Bridge 1) and 10 (Wireless Bridge 2)
are used. In addition to the values below, the network SSID and security must be configured according
to the settings in the Access Point (AP) on Wireless Bridge 1.
Parameter Wireless Bridge 1 Wireless Bridge 2 Comment
IP Configuration
IP address 192.168.0.98 192.168.0.99
Subnet Mask 255.255.0.0 255.255.0.0
Gateway 192.168.0.98 192.168.0.98
IP Assignment Static Static DHCP is not supported in this mode
WLAN - Network
Network Name (SSID) SSID of AP Leave blank
WLAN - General
Operational Mode Infrastructure
WLAN - Client Mode
Mode Ethernet Bridge Ethernet Bridge
IP Address 192.168.0.99 192.168.0.98
UDP Port 7 7