Instructions

Anybus Communicator - EtherNet/IP Interface Installation Sheet
www.anybus.comSP0904, rev. 1.10, Mar 2015
1
3
5
2
4
6
Module Front
1
9
5
6
1
2
4
1
Bottom View
Subnetwork Connector
Pin no. Description
1 +5V OUT
2 RS232 Rx
3 RS232 Tx
4NC
5 Signal GND
6 RS422 Rx+
7 RS422 Rx-
8 RS485+ / RS422 Tx+
9 RS485- / RS422 Tx-
PC Connector:
1. GND
2. GND
3. RS232 Rx
4. RS232 Tx
Power:
1. +24 V DC
2. GND
Accessories Checklist
The following items are required for installation:
• Anybus Communicator Resource CD (Includes confi guration
software, manuals and application notes)
• RS232 confi guration cable
• Subnetwork connector
• Ethernet cable and connector (not included)
Installation and Startup Summary
• Mount the Communicator on the DIN-rail.
• Connect the Communicator to the Ethernet/IP network.
• Connect the Communicator to the subnetwork.
• Connect the confi guration cable between the Communicator
and the PC containing the Anybus Confi guration Manager
software (ACM).
• Power on the Communicator (+24 V DC).
• Confi gure the Communicator using ACM.
• Include the Anybus Communicator EDS fi le in the
Ethernet/IP confi guration tool.
• Confi gure and start the Ethernet/IP network.
Further information and documents about this product can be
found at the product pages on www.anybus.com.
Ethernet/IP Connectors
Pin no Description
1 TD+
2 TD-
3 RD+
4 Termination
5 Termination
6 RD-
7 Termination
8 Termination
18
LED Indicators
LED Indication Description
1 (Module Status) Off
Green
Flashing Green
Flashing Red
Red
Flashing Green/Red
No power
Controlled by a scanner in run state
Not confi gured, or scanner in idle state
Minor fault (recoverable)
Major fault (unrecoverable)
Self-test in progress
2 (Network Status) Off
Green
Flashing Green
Red
Flashing Red
Flashing Green/Red
No IP address, or no power
Online, one or more EtherNet/IP connec-
tions established
Online, no connections established
Duplicate IP address detected. Fatal error.
One or more connections timed out
Self-test in progress
3 (Link) Off
Green
No link
Connected to an Ethernet network
4 (Activity) Off
Flashing Green
No Ethernet activity
Activity, receiving/transmitting Ethernet
packets
5 (Subnet Status) Flashing green
Green
Red
Running, but one or more transaction errors
Running
Transaction error/timeout or subnet stopped
6 (Device Status) Off
Alternating red/green
Green
Flashing green
Red
Flashing red
Power off
Invalid or missing confi guration
Initializing
Running
Bootloader mode
Note the fl ash sequence pattern and contact
HMS support