Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
9.2. Communicator LED Indicators
NOTE
Before you can verify operaon you must congure the Communicator.
Figure 79. Communicator status (A), High level Network/Client (B), Subnetwork 2 (C) and (D) Security Switch
LED A LED B LED C LED D
Operaon Status Gateway status PROFIBUS Subnetwork Security switch
O No power No data exchange No power/Excepon/
Subnetwork not
running/Node is
switched o via a
control word
No power/Security
switch is unlocked/
Excepon/Fatal error
Green, ashing Startup phase Clear, data exchange Running, one or more
nodes are oine
N/A
Green Operaonal Operate, data exchange Running Security switch is locked
Red Excepon/Fatal error FATAL event Fatal error N/A
Red, one ash Excepon/Fatal error Parameterizaon error Fatal error N/A
Red, two ash Excepon/Fatal error PROFIBUS conguraon
error
Fatal error N/A
Green/Red,
ashing
Power up self-test/
Firmware update/
Firmware recovery
N/A N/A N/A
Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial Communicator LED Indicators
Page 96 of 134 SCM-1202-177 1.2