Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
4. About Anybus Communicator
4.1. Serial Protocol Communicaon
4.1.1. Serial Protocol Types
The gateway features three disnct modes of operaon for the subnetwork communicaon, called Modbus RTU,
Custom Request/Response and Custom Produce/Consume.
Figure 1. Communicaon, Serial protocol
Modbus RTU
By default the Communicator uses the Modbus RTU serial protocol.
The Communicator uses Modbus transacons dened by the Modbus standard.
The Communicator acts as a client on the subnetwork, and the serial communicaon takes place in a request/
response fashion.
The nodes on the network are not permied to issue messages unless they have been addressed by the
Communicator rst.
Custom Request/Response
In this mode, you can dene your own serial transacons to handle a wide range of custom serial protocols.
The Communicator acts as a generic serial client on the subnetwork.
The serial communicaon takes place in a request/response fashion.
Custom Produce/Consume
In this mode, you can dene your own serial transacons to handle a wide range of custom serial protocols.
The Communicator may consume and/or produce messages on the subnetwork.
There is no client-server relaonship between the nodes on the network, messages are spontaneously produced
or consumed when data is available.
Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial About Anybus Communicator
Page 6 of 134 SCM-1202-177 1.2