Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
11.2. Clear and Revert Conguraon
You can restore all sengs in a conguraon to the default sengs.
Procedure
Figure 103. Files & rmware page
When you want to clear a conguraon and return to the default sengs.
To clear the conguraon:
1. On the Files & rmware page, click Clear.
2. In the Conrm clear window, click Clear.
3. To apply the change, click Apply in the web-interface header, and follow the instrucons.
When you want to remove any conguraon made in a current session and re-load the conguraon from the
gateway.
To Revert the conguraon:
1. On the Files & rmware page, click Revert.
2. In the Conrm revert window, click Revert.
3. To apply the change, click Apply in the web-interface header, and follow the instrucons.
Clear and Revert Conguraon Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial
SCM-1202-177 1.2 Page 119 of 134