Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
12. Troubleshoong
12.1. Diagnoscs
12.1.1. Serial RS-232/485 Data Monitor
On the Serial RS-232/485 page you can monitor how the data ow between the nodes and the gateway changes
over me.
Figure 106. Serial RS-232/485 page
The table can contain at most 10000 messages. When the limit is reached, the oldest messages are discarded
when new messages are added.
Choose how data is displayed
• To choose if the data should be displayed in Hexadecimal, Decimal or ASCII, click Hex, Dec or Ascii.
Start and Stop Data ow
• To start the data ow, click Start.
• To end the data ow, click Stop.
Export data ow
• To export the data ow, click Export.
An Excel le with the data ow is downloaded to your PC.
Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial Troubleshoong
Page 122 of 134 SCM-1202-177 1.2