Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
3. Leave the Communicator for 10 minutes.
The Gateway status led indicator ashes red and green unl the rmware upgrade is completed.
Figure 115. Firmware upgrade LED indicaon
Result
The Communicator recover and return to normal operaon.
Figure 116. Recover and return to normal operaon
To Do Next
To check LED status, refer to Communicator LED Indicators (page 96).
Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial Firmware Upgrade Error Management
Page 128 of 134 SCM-1202-177 1.2