Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
Frame Fields
The Frame editor is used to design custom transacon templates.
The Frame editor with Frame elds is available when either the Custom Request/Response or Custom Produce/
Consume serial protocol is enabled.
Figure 4. Frame editor
Frame elds are low level enes used to compose transacons.
A frame object can represent a:
• xed value, a constant
• range of values, limit objects
• block of data or a calculated checksum
Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial Serial Protocol Communicaon
Page 8 of 134 SCM-1202-177 1.2