Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
Data bits
Data bits is the number of bits used in the data representaon of characters in the telegrams.
The rate for Modbus RTU is 7 data bits or 8 data bits. The default seng is 8 data bits.
Seng Value
Baud rate 1200 baud
1800 baud
2400 baud
4800 baud
9600 baud, Default value
19200 baud
35700 baud
38400 baud
57600 baud
115200 baud
128000 baud
Parity
Specify if parity should be used to detect errors in the data.
Select parity value from the Parity drop-down menu.
Seng Value Descripon
Parity None, Default value No parity checking Parity bit is not transmied
Odd Odd parity checking
Even Even parity checking
Stop bits
Specify the number of stop bits used to indicate the end of data transmission.
Select a stop bits value from the Stop bits drop-down menu.
Seng Value
Stop bits 1 stop bit, Default value
2 stop bit
Apply Conguraon
To apply the sengs, click Apply in the web-interface header, and follow the instrucons.
General Subnetwork Sengs Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial
SCM-1202-177 1.2 Page 47 of 134