Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
7.7. Build Transacon Template
Before You Begin
Ensure that you have applied the Custom Request/Response or Custom Produce/Consume serial protocol, refer
to Communicaon Serial Protocol (page 45).
7.7.1. Add Transacon Template
Procedure
Add a transacon template:
1. In the web-interface le sidebar menu, click Transacon templates.
2. To select the template you want to use, click the Add drop-down buon.
Opons for the Custom Request/Response Protocol
• To add a new empty template without any frame elds, select Empty template.
Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial Build Transacon Template
Page 54 of 134 SCM-1202-177 1.2