Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
• End paern
The package consists of a data secon followed by an end character to indicate where the data secon ends.
End paern is used to dene whether the delimiter is an end character or an end paern, which depends on
whether the message is forwarded from the subnetwork or sent as process data.
• None
The package contains only the data secon. By measuring the total length of the message, the length of the
data secon can be calculated.
3. When a delimiter is set to End paern: In the End paern eld, enter the value that will dene the end of
the payload.
Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial Build Transacon Template
Page 64 of 134 SCM-1202-177 1.2