Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
When using the Request/Response or Produce/Consume Serial Protocol
Figure 49. Add new empty template
• Click Add and select Add from new transacon template.
You are redirected to the Transacon template page.
A new empty template is added to the Transacon templates list.
NOTE
You must build the transacons before you can use the template, refer to Build Transacon
Template (page 54).
Figure 50. Add new empty template
Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial Nodes and Transacons
Page 70 of 134 SCM-1202-177 1.2