Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
7.8.5. Transacon Sengs
Before You Begin
NOTE
When a custom transacon is selected, the custom transacon template is locked for eding.
For Modbus transacon reference guide, refer to Modbus Transacons (page 131).
Procedure
Figure 52. Modbus TCP Protocol
Figure 53. Custom request/response Protocol
1. In the node list, select a node to congure.
2. In the transacons list, select a transacon to congure.
The transacons sidebar opens, on the right side of the screen.
3. Enter a transacon name.
By default, the node is assigned the name New transacon.
Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial Nodes and Transacons
Page 72 of 134 SCM-1202-177 1.2