Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
7.11. Apply Conguraon
Before You Begin
NOTE
When you apply the conguraon, any exisng conguraon is overwrien.
Figure 70. Disconnect the Communicator from the PROFIBUS network
Before you can apply the conguraon, ensure that there is no acve communicaon on the PROFIBUS network
where the Communicator is connected.
Procedure
To make the sengs take eect, download the conguraon to the Communicator:
1. In the web-interface header, click Apply
Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial Apply Conguraon
Page 86 of 134 SCM-1202-177 1.2