Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
7.12. To Use an Exisng Conguraon
When you have congured a Communicator and want to use the same sengs to congure addional
Communicator, do the following.
Procedure
Figure 71. Files & rmware page
In the built-in web-interface of the Communicator with the conguraon you want to use:
1. On the Files & rmware page, click Export
The conguraon is saved in an conf le and downloaded to your PC.
In the built-in web-interface of the new Communicator to be congured:
2. On the Files & rmware page, click Import
3. In the Import conguraon window, click Select le (.conf).
4. In the Open dialog box, browse to and select the conguraon le and click Open.
5. To import the conguraon le, click Import.
Result
All the conguraon sengs are imported.
To apply the sengs, click Apply in the web-interface header, and follow the instrucons.
Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial To Use an Exisng Conguraon
Page 88 of 134 SCM-1202-177 1.2