Instructions

7.13. To Use an Communicator Classic Conguraon
Before You Begin
NOTE
Only the Communicator Classic serial conguraon sengs can be imported.
The I/O data map and high-level network sengs are not supported and must be set manually in
the Communicator built-in web interface.
Communicator Classic Classic conguraon intended use
The intended use of the Communicator Classic conguraon import is to:
• convert custom protocols.
• get a new Communicator unit up and running quickly and then complete the conguraon in the
Communicator built-in web interface.
Conguraon les containing standard Modbus RTU commands
• It is not recommended to import Communicator Classic conguraon les containing standard Modbus RTU
commands if you need to be able to easily make change to the imported conguraon.
• When standard Modbus RTU commands are imported, they are converted to Custom Request/Response
transacons. See Communicaon Serial Protocol (page 45).
• The behavior of the imported standard Modbus RTU commands is preserved, but adding or changing Modbus
RTU commands in Custom Request/Response mode is more dicult than in Modbus RTU mode.
Procedure
Figure 72. Files & rmware page
1. On the Files & rmware page, click Import Anybus Communicator Classic conguraon
2. In the Import Anybus Communicator Classic conguraon window, click Select le (.cfg).
To Use an Communicator Classic Conguraon Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial
SCM-1202-177 1.2 Page 89 of 134