Instructions
Table Of Contents
- Anybus® Communicator™ - PROFIBUS to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Apply Configuration
- 7.12. To Use an Existing Configuration
- 7.13. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
8. PLC Conguraon
8.1. Export I/O Data Map
When conguring the communicaon between the PLC and the nodes on the subnetwork, use the I/O data map
as a specicaon to ensure that the transacons match.
Figure 75. I/O data map page
On the I/O data map page you can export the I/O data map in an Excel XLS le, where all the nodes and
transacons are listed.
To export the I/O data map:
1. Click Export.
An Excel XLS le with the mapping is downloaded to your PC.
8.2. Export Product GSD File
Opon if the PLC program requires a product le, GSD (General Staon Descripon) le, describing how the
Communicator can be used on the high level network.
Figure 76. Export Product GSD File
You nd the PROFIBUS GSD le on the Communicator built-in web interface PROFIBUS page, Files & rmware
page and on the Support page.
To export the GSD le:
1. Click GSD le.
The GSD le is downloaded to your PC.
PLC Conguraon Anybus
®
Communicator
™
- PROFIBUS to Modbus RTU/Serial
SCM-1202-177 1.2 Page 91 of 134