Instructions
Table Of Contents
- 1 Preface
- 2 Safety
- 3 Preparation
- 4 About Anybus Communicator
- 5 Installation
- 6 Configuration Quick Guide
- 7 Communicator Configuration
- 7.1 Connecting the Communicator
- 7.2 Access the Built-In Web Interface From HMS IPconfig
- 7.3 Access the Built-In Web Interface From a Web Browser
- 7.4 Communicator Built-In Web Interface Overview
- 7.5 General Subnetwork Settings
- 7.6 About Transaction Templates
- 7.7 Build Transaction Templates
- 7.8 Nodes and Transactions
- 7.9 High Level Network Settings
- 7.10 Naming the Host
- 7.11 Station Name
- 7.12 I/O Data Map
- 7.13 Apply Configuration
- 7.14 Use an Existing Configuration
- 8 PLC Configuration
- 9 Verify Operation
- 10 Use Cases
- 11 Maintenance
- 12 Troubleshooting
- 13 Technical Data
- A Reference Guides
Use Cases
99 (124)
10.2.6 Set Up Node and Transactions
1. Add a node and select it.
2. In Node settings configure the node with the following settings:
Node settings Value
Node address
1
My Drive is set up as a node with Node address 1.
Name My Drive
Timeout time
1000 ms (default)
Reconnecting time
10000 ms (default)
Retries
0 (default)
3. Add four transactions to the My Drive node and configure them with the following settings:
My Drive contains the following parameters
Transaction name Transaction template Index Sub index
Control Word Write Parameter (0x02)
1 1
Speed Write Parameter (0x02)
1 2
Status Word
Read Parameter (0x01)
2 1
Actual Speed Read Parameter (0x01)
2 2
Anybus
®
Communicator
™
User Manual
SCM-1202-176 1.0 en-US