Instructions
Table Of Contents
- 1 Preface
- 2 Safety
- 3 Preparation
- 4 About Anybus Communicator
- 5 Installation
- 6 Configuration Quick Guide
- 7 Communicator Configuration
- 7.1 Connecting the Communicator
- 7.2 Access the Built-In Web Interface From HMS IPconfig
- 7.3 Access the Built-In Web Interface From a Web Browser
- 7.4 Communicator Built-In Web Interface Overview
- 7.5 General Subnetwork Settings
- 7.6 About Transaction Templates
- 7.7 Build Transaction Templates
- 7.8 Nodes and Transactions
- 7.9 High Level Network Settings
- 7.10 Naming the Host
- 7.11 Station Name
- 7.12 I/O Data Map
- 7.13 Apply Configuration
- 7.14 Use an Existing Configuration
- 8 PLC Configuration
- 9 Verify Operation
- 10 Use Cases
- 11 Maintenance
- 12 Troubleshooting
- 13 Technical Data
- A Reference Guides
Use Cases
102 (124)
10.3.3 Choose Serial Protocol Type
The Barcode Scanner is using a produce/consume protocol to access parameters addressed with
index and sub index.
► On the Serial RS232/485 page, select Custom Produce/Consume.
10.3.4 Set Up Serial Communication
Set up the communication between the Communicator and the Barcode Scanner.
In the Serial RS232/485 page, configure the Communication settings.
Used the following settings:
Frame fields Value
Physical standard
RS-232
Baud rate 9600 baud
Data bits 8 bits
Parity 1
Stop bits 1 stop bit
Anybus
®
Communicator
™
User Manual
SCM-1202-176 1.0 en-US