Instructions
Table Of Contents
- 1 Preface
- 2 Safety
- 3 Preparation
- 4 About Anybus Communicator
- 5 Installation
- 6 Configuration Quick Guide
- 7 Communicator Configuration
- 7.1 Connecting the Communicator
- 7.2 Access the Built-In Web Interface From HMS IPconfig
- 7.3 Access the Built-In Web Interface From a Web Browser
- 7.4 Communicator Built-In Web Interface Overview
- 7.5 General Subnetwork Settings
- 7.6 About Transaction Templates
- 7.7 Build Transaction Templates
- 7.8 Nodes and Transactions
- 7.9 High Level Network Settings
- 7.10 Naming the Host
- 7.11 Station Name
- 7.12 I/O Data Map
- 7.13 Apply Configuration
- 7.14 Use an Existing Configuration
- 8 PLC Configuration
- 9 Verify Operation
- 10 Use Cases
- 11 Maintenance
- 12 Troubleshooting
- 13 Technical Data
- A Reference Guides
Configuration Quick Guide 24 (124)
6 Configuration Quick Guide
This section is intended to give you a short overview of the tasks you need to perform to
configure the Communicator.
For detailed information, please refer to Communicator Configuration, p. 31.
6.1 Prepare Configuration
1. Connecting to the high level network
Connect the Communicator to the
PROFINET high level network.
2. Connecting the Communicator to the subnetwork
Connect the Communicator to the serial
RS232/RS485 subnetwork.
3. Connecting to PC and power
a. Connect an Ethernet cable between
the Communicator configuration port
and your PC.
b. Connect the Communicator to a
power supply.
Anybus
®
Communicator
™
User Manual
SCM-1202-176 1.0 en-US