Instructions
Table Of Contents
- 1 Preface
- 2 Safety
- 3 Preparation
- 4 About Anybus Communicator
- 5 Installation
- 6 Configuration Quick Guide
- 7 Communicator Configuration
- 7.1 Connecting the Communicator
- 7.2 Access the Built-In Web Interface From HMS IPconfig
- 7.3 Access the Built-In Web Interface From a Web Browser
- 7.4 Communicator Built-In Web Interface Overview
- 7.5 General Subnetwork Settings
- 7.6 About Transaction Templates
- 7.7 Build Transaction Templates
- 7.8 Nodes and Transactions
- 7.9 High Level Network Settings
- 7.10 Naming the Host
- 7.11 Station Name
- 7.12 I/O Data Map
- 7.13 Apply Configuration
- 7.14 Use an Existing Configuration
- 8 PLC Configuration
- 9 Verify Operation
- 10 Use Cases
- 11 Maintenance
- 12 Troubleshooting
- 13 Technical Data
- A Reference Guides
Communicator Configuration 32 (124)
7.2 Access the Built-In Web Interface From HMS IPconfig
Before You Begin
Download the software application HMS IPconfig installation files and user documentation from
www.anybus.com/support.
The Communicator default IP address is 192.168.0.10.
To access the Communicator built-in web interface, ensure that Port 80 TCP is open in your Firewall.
This applies to any Firewall between the web browser and the gateway.
To access the Communicator built-in web interface from HMS IPconfig, ensure that port Port 3250 UDP is
open in your PC Windows Firewall.
Make sure the security switch is unlocked. HMS IPconfig cannot configure the Communicator if the
security switch is locked.
Procedure
1. Install HMS IPconfig on your PC.
2. Open HMS IPconfig.
→ HMS IPconfig automatically starts scanning for compatible and active HMS devices.
→ Found HMS devices are added to the device list.
3. To open the settings pane, click on the Communicator in the device list.
4. Change the Communicator IP address to one within the same IP address range as your PC.
Anybus
®
Communicator
™
User Manual
SCM-1202-176 1.0 en-US