Instructions
Table Of Contents
- 1 Preface
- 2 Safety
- 3 Preparation
- 4 About Anybus Communicator
- 5 Installation
- 6 Configuration Quick Guide
- 7 Communicator Configuration
- 7.1 Connecting the Communicator
- 7.2 Access the Built-In Web Interface From HMS IPconfig
- 7.3 Access the Built-In Web Interface From a Web Browser
- 7.4 Communicator Built-In Web Interface Overview
- 7.5 General Subnetwork Settings
- 7.6 About Transaction Templates
- 7.7 Build Transaction Templates
- 7.8 Nodes and Transactions
- 7.9 High Level Network Settings
- 7.10 Naming the Host
- 7.11 Station Name
- 7.12 I/O Data Map
- 7.13 Apply Configuration
- 7.14 Use an Existing Configuration
- 8 PLC Configuration
- 9 Verify Operation
- 10 Use Cases
- 11 Maintenance
- 12 Troubleshooting
- 13 Technical Data
- A Reference Guides
Communicator Configuration 34 (124)
7.3 Access the Built-In Web Interface From a Web Browser
Before You Begin
The Communicator default IP address is 192.168.0.10.
To access the Communicator built-in web interface, ensure that Port 80 TCP is open in your Firewall.
This applies to any Firewall between the web browser and the gateway.
When you change to a static IP address on your computer, internet access may be lost.
Procedure
1. On the PC accessing the Communicator built-in web interface, set a static IP address within
the same IP address range as the Communicator IP address.
2. Open a web browser.
3. Click to select the Address bar and enter the Communicator IP address.
4. To open the built-in web interface Home page, press Enter.
Anybus
®
Communicator
™
User Manual
SCM-1202-176 1.0 en-US