Instructions
Table Of Contents
- 1 Preface
- 2 Safety
- 3 Preparation
- 4 About Anybus Communicator
- 5 Installation
- 6 Configuration Quick Guide
- 7 Communicator Configuration
- 7.1 Connecting the Communicator
- 7.2 Access the Built-In Web Interface From HMS IPconfig
- 7.3 Access the Built-In Web Interface From a Web Browser
- 7.4 Communicator Built-In Web Interface Overview
- 7.5 General Subnetwork Settings
- 7.6 About Transaction Templates
- 7.7 Build Transaction Templates
- 7.8 Nodes and Transactions
- 7.9 High Level Network Settings
- 7.10 Naming the Host
- 7.11 Station Name
- 7.12 I/O Data Map
- 7.13 Apply Configuration
- 7.14 Use an Existing Configuration
- 8 PLC Configuration
- 9 Verify Operation
- 10 Use Cases
- 11 Maintenance
- 12 Troubleshooting
- 13 Technical Data
- A Reference Guides
Communicator Configuration 64 (124)
7.8.5 Transaction Settings
Before You Begin
When a custom transaction is selected, the custom transaction template is locked for editing.
For Modbus transaction reference guide, refer to Modbus Transactions, p. 121.
Procedure
Modbus RTU Protocol:
Custom Request/Response Protocol:
1. In the nodes list, select a node to configure.
2. In the transactions list, select a transaction to configure.
→ The transaction sidebar opens, on the right side of the screen.
3. Enter a transaction name.
By default, the node is assigned the name New transaction.
4. Select a transaction type from the Modbus transaction/Custom transaction drop-down
menu.
The transaction type defines what the node should perform when the transaction is
executed.
Anybus
®
Communicator
™
User Manual
SCM-1202-176 1.0 en-US