Instructions
Table Of Contents
- 1 Preface
- 2 Safety
- 3 Preparation
- 4 About Anybus Communicator
- 5 Installation
- 6 Configuration Quick Guide
- 7 Communicator Configuration
- 7.1 Connecting the Communicator
- 7.2 Access the Built-In Web Interface From HMS IPconfig
- 7.3 Access the Built-In Web Interface From a Web Browser
- 7.4 Communicator Built-In Web Interface Overview
- 7.5 General Subnetwork Settings
- 7.6 About Transaction Templates
- 7.7 Build Transaction Templates
- 7.8 Nodes and Transactions
- 7.9 High Level Network Settings
- 7.10 Naming the Host
- 7.11 Station Name
- 7.12 I/O Data Map
- 7.13 Apply Configuration
- 7.14 Use an Existing Configuration
- 8 PLC Configuration
- 9 Verify Operation
- 10 Use Cases
- 11 Maintenance
- 12 Troubleshooting
- 13 Technical Data
- A Reference Guides
Communicator Configuration 67 (124)
7.9 High Level Network Settings
Configure the PROFINET network settings.
7.9.1 To Use Automatic I/O Sizes
By default, the Communicator is set to use automatic I/O sizes.
The size of the input data, Data Size to PROFINET, and the output data, Data Size from PROFINET,
is determined by the subnetwork configuration.
The Data sizes can be between 0-1024 bytes.
In the Communicator built-in web interface, the Use Automatic I/O Sizes checkbox is selected.
7.9.2 To Configure I/O Sizes Manually
1. Deselect the Use Automatic I/O Sizes checkbox.
2. Enter a value for Data Size to PROFINET and a value for Data Size from PROFINET.
Anybus
®
Communicator
™
User Manual
SCM-1202-176 1.0 en-US