Instructions
Table Of Contents
- 1 Preface
- 2 Safety
- 3 Preparation
- 4 About Anybus Communicator
- 5 Installation
- 6 Configuration Quick Guide
- 7 Communicator Configuration
- 7.1 Connecting the Communicator
- 7.2 Access the Built-In Web Interface From HMS IPconfig
- 7.3 Access the Built-In Web Interface From a Web Browser
- 7.4 Communicator Built-In Web Interface Overview
- 7.5 General Subnetwork Settings
- 7.6 About Transaction Templates
- 7.7 Build Transaction Templates
- 7.8 Nodes and Transactions
- 7.9 High Level Network Settings
- 7.10 Naming the Host
- 7.11 Station Name
- 7.12 I/O Data Map
- 7.13 Apply Configuration
- 7.14 Use an Existing Configuration
- 8 PLC Configuration
- 9 Verify Operation
- 10 Use Cases
- 11 Maintenance
- 12 Troubleshooting
- 13 Technical Data
- A Reference Guides
Communicator Configuration 68 (124)
7.9.3 To Use DHCP Server
By default, the IP settings are provided by the high level network DHCP server.
The DHCP enabled checkbox is selected.
Default Communicator IP Settings
The Communicator comes with the following factory default IP settings:
Setting
Default value
Web configuration
IP address
192.168.0.10
Subnet mask
255.255.255.0
Gateway address There is no default Gateway address.
Primary DNS server
There is no default Primary DNS server.
Secondary DNS server There is no default Secondary DNS server.
DHCP
Enabled
Host name
There is no default Host name.
Anybus
®
Communicator
™
User Manual
SCM-1202-176 1.0 en-US