Instructions
Table Of Contents
- 1 Preface
- 2 Safety
- 3 Preparation
- 4 About Anybus Communicator
- 5 Installation
- 6 Configuration Quick Guide
- 7 Communicator Configuration
- 7.1 Connecting the Communicator
- 7.2 Access the Built-In Web Interface From HMS IPconfig
- 7.3 Access the Built-In Web Interface From a Web Browser
- 7.4 Communicator Built-In Web Interface Overview
- 7.5 General Subnetwork Settings
- 7.6 About Transaction Templates
- 7.7 Build Transaction Templates
- 7.8 Nodes and Transactions
- 7.9 High Level Network Settings
- 7.10 Naming the Host
- 7.11 Station Name
- 7.12 I/O Data Map
- 7.13 Apply Configuration
- 7.14 Use an Existing Configuration
- 8 PLC Configuration
- 9 Verify Operation
- 10 Use Cases
- 11 Maintenance
- 12 Troubleshooting
- 13 Technical Data
- A Reference Guides
Communicator Configuration 73 (124)
7.12.3 Map Area
Map area options
You must specify the map area to use for each transaction in the I/O data map.
Select one of the following Map area options:
• Input/Output: The transaction data is sent/recieved to/from the high level network.
• General: This area is used for transferring transaction data between individual nodes on the
subnetwork.
When General is selected, the transaction data cannot be accessed from the high level
network.
• Unmapped: The transaction data is not used.
Start address
For Input/Output and General, you can enter a start address for the transaction data.
Anybus
®
Communicator
™
User Manual
SCM-1202-176 1.0 en-US