Instructions
Table Of Contents
- 1 Preface
- 2 Safety
- 3 Preparation
- 4 About Anybus Communicator
- 5 Installation
- 6 Configuration Quick Guide
- 7 Communicator Configuration
- 7.1 Connecting the Communicator
- 7.2 Access the Built-In Web Interface From HMS IPconfig
- 7.3 Access the Built-In Web Interface From a Web Browser
- 7.4 Communicator Built-In Web Interface Overview
- 7.5 General Subnetwork Settings
- 7.6 About Transaction Templates
- 7.7 Build Transaction Templates
- 7.8 Nodes and Transactions
- 7.9 High Level Network Settings
- 7.10 Naming the Host
- 7.11 Station Name
- 7.12 I/O Data Map
- 7.13 Apply Configuration
- 7.14 Use an Existing Configuration
- 8 PLC Configuration
- 9 Verify Operation
- 10 Use Cases
- 11 Maintenance
- 12 Troubleshooting
- 13 Technical Data
- A Reference Guides
Communicator Configuration 76 (124)
7.12.6 Offline Option
Offline mode is used to define what data to send if the network connection or connection with a
specific node is lost.
You must specify the offline mode to use for each transaction on the I/O data map.
Select one of the following Offline options:
• Clear (Default): The data is cleared and the value 0 is sent.
• Freeze: The Communicator holds the value until the connection is restored.
• No scanning: Stop sending this transaction on the sub-network. This option is only valid for
produce and request transactions.
Anybus
®
Communicator
™
User Manual
SCM-1202-176 1.0 en-US