Instructions
Table Of Contents
- 1 Preface
- 2 Safety
- 3 Preparation
- 4 About Anybus Communicator
- 5 Installation
- 6 Configuration Quick Guide
- 7 Communicator Configuration
- 7.1 Connecting the Communicator
- 7.2 Access the Built-In Web Interface From HMS IPconfig
- 7.3 Access the Built-In Web Interface From a Web Browser
- 7.4 Communicator Built-In Web Interface Overview
- 7.5 General Subnetwork Settings
- 7.6 About Transaction Templates
- 7.7 Build Transaction Templates
- 7.8 Nodes and Transactions
- 7.9 High Level Network Settings
- 7.10 Naming the Host
- 7.11 Station Name
- 7.12 I/O Data Map
- 7.13 Apply Configuration
- 7.14 Use an Existing Configuration
- 8 PLC Configuration
- 9 Verify Operation
- 10 Use Cases
- 11 Maintenance
- 12 Troubleshooting
- 13 Technical Data
- A Reference Guides
Communicator Configuration 79 (124)
7.13 Apply Configuration
Before You Begin
When you apply the configuration, any existing configuration is overwritten.
Disconnect the Communicator from the PROFINET network
Before you can apply the configuration, ensure that there is no active communication on the
PROFINET network where the Communicator is connected.
Procedure
To make the settings take effect, download the configuration to the Communicator:
1. In the web-interface header, click Apply
2. To confirm download, click Apply.
→ The configured settings are downloaded and applied to the system.
Anybus
®
Communicator
™
User Manual
SCM-1202-176 1.0 en-US