Instructions
Table Of Contents
- 1 Preface
- 2 Safety
- 3 Preparation
- 4 About Anybus Communicator
- 5 Installation
- 6 Configuration Quick Guide
- 7 Communicator Configuration
- 7.1 Connecting the Communicator
- 7.2 Access the Built-In Web Interface From HMS IPconfig
- 7.3 Access the Built-In Web Interface From a Web Browser
- 7.4 Communicator Built-In Web Interface Overview
- 7.5 General Subnetwork Settings
- 7.6 About Transaction Templates
- 7.7 Build Transaction Templates
- 7.8 Nodes and Transactions
- 7.9 High Level Network Settings
- 7.10 Naming the Host
- 7.11 Station Name
- 7.12 I/O Data Map
- 7.13 Apply Configuration
- 7.14 Use an Existing Configuration
- 8 PLC Configuration
- 9 Verify Operation
- 10 Use Cases
- 11 Maintenance
- 12 Troubleshooting
- 13 Technical Data
- A Reference Guides
Verify Operation 84 (124)
9 Verify Operation
Before You Begin
Ensure that the Communicator is connected to your PC, to a power supply and to the OT
network.
Refer to Installation, p. 16.
9.1 Communicator Status Monitor
On the Home page, you can get a quick overview of the network and the Communicator
operating status.
Gateway status
Overview the Communicator LED indications remotely.
Refer to Communicator LED Indicators, p. 86.
Node Status
Overview the status for each node added to the subnetwork.
Network Status and Settings
Overview communication status and the current networks settings.
Anybus
®
Communicator
™
User Manual
SCM-1202-176 1.0 en-US