Instructions
Table Of Contents
- 1 Preface
- 2 Safety
- 3 Preparation
- 4 About Anybus Communicator
- 5 Installation
- 6 Configuration Quick Guide
- 7 Communicator Configuration
- 7.1 Connecting the Communicator
- 7.2 Access the Built-In Web Interface From HMS IPconfig
- 7.3 Access the Built-In Web Interface From a Web Browser
- 7.4 Communicator Built-In Web Interface Overview
- 7.5 General Subnetwork Settings
- 7.6 About Transaction Templates
- 7.7 Build Transaction Templates
- 7.8 Nodes and Transactions
- 7.9 High Level Network Settings
- 7.10 Naming the Host
- 7.11 Station Name
- 7.12 I/O Data Map
- 7.13 Apply Configuration
- 7.14 Use an Existing Configuration
- 8 PLC Configuration
- 9 Verify Operation
- 10 Use Cases
- 11 Maintenance
- 12 Troubleshooting
- 13 Technical Data
- A Reference Guides
Use Cases
89 (124)
10.1.3 Choose Serial Protocol Type
The Temperature Regulator is using a request/response protocol to access parameters addressed
with index and sub index.
► On the Serial RS232/485 page, select Modbus RTU.
10.1.4 Set Up Serial Communication
Set up the communication between the Communicator and the Temperature Regulator.
In the Serial RS232/485 page, configure the Communication settings.
Used the following settings:
Frame fields Value
Physical standard
RS-232
Baud rate 19200 baud
Data bits 8 bits
Parity None
Stop bits 2 stop bit
Anybus
®
Communicator
™
User Manual
SCM-1202-176 1.0 en-US