Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
Create Write Parameter (0x02)
The Communicator writes values delivered from the PLC to the My Drive node.
Figure 96. Write Parameter (0x02)
1. Add an Empty template and select it.
2. Name the template Write parameter (0x02).
3. In the Frame editor Request area, add six frame objects with the following sengs:
Table 7. Request frame objects
Frame object Name Bytes/Length Type/Checksum
type
Endianess Fixed eld Value (Hex)
Constant Funcon code 1 Byte N/A Yes N/A
Node address Node ID 1 Byte N/A N/A N/A
Constant Index 2 Word (two bytes) Big-endian No Min 0
Max 1000
Constant Sub index 1 Byte N/A No Min 0
Max 255
Data Data 2 Byte N/A Yes N/A
Checksum Checksum 2 CRC N/A N/A N/A
Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial AC Motor Drive - Custom Request/Response Use Case
Page 106 of 133 SCM-1202-152 Version 1.12