Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
Procedure
Figure 103. Read Barcode Data Parameter
1. Add an Empty consume template and select it.
2. Name the template Read Barcode Data.
3. In the Frame editor, add four frame eld with the following sengs:
Table 13. Consume frame elds
Frame elds Name Type Value Fixed eld Maximum
payload
length
Process data
delimiter
Subnet
delimiter
End
paern
Variable data Barcode Data N/A N/A Yes, set
here
31 bytes None None 0
Constant Carriage
Return
character
(CR)
Byte (1
byte)
13 Yes, set
here
N/A N/A N/A N/A
Constant Line Feed
character (LF)
Byte (1
byte)
10 Yes, set
here
N/A N/A N/A N/A
Barcode Scanner - Custom Produce/Consume Use Case Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial
SCM-1202-152 Version 1.12 Page 113 of 133