Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
11.3.4. Update Firmware
Before You Begin
IMPORTANT
To eliminate the risk of interference with plant operaon, rmware update is only available when the
Communicator is disconnected from the OT networks.
Ensure that the Communicator is disconnected from the OT networks.
Procedure
Figure 110. Files & rmware page
To update the rmware:
1. On the Files & rmware page, click Upload.
2. In the Upload Firmware window, click Select rmware (.hi).
3. In the Open dialog box, browse to and select the rmware le and click Open.
4. To start the rmware upgrade, click Update rmware.
The rmware le is validated and transferred.
Result
• If the rmware le pass the validaon: The rmware is upgraded and then the Communicator automacally
reboots, for the upgrade to take eect.
• If the rmware le is rejected: An error message appear.
Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial Firmware Management
Page 120 of 133 SCM-1202-152 Version 1.12