Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
3. While holding the reset buon, reconnect the Communicator to power.
Figure 117. Hold Reset buon and reconnect power
4. Release the reset buon.
The Communicator enters excepon state.
5. Reboot the Communicator.
Result
When the Communicator has successfully rebooted, the Communicator conguraon is reset to the factory
default conguraon or the current conguraon aer rmware upgrade.
To Do Next
To ensure that the Communicator built-in web-interface is synchronized.
1. Open the the Communicator built-in web interface.
2. Navigate to the Files & rmware page and click Revert.
Figure 118. Files & rmware, Revert
Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial Reset to Factory Sengs
Page 126 of 133 SCM-1202-152 Version 1.12