Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
14.4. Modus Excepon Codes
Excepon Code Name Descripon
01 Illegal Funcon The server does not recognize or permit the funcon code.
02 Illegal Data Address The data address (register, discrete input or coil number) is not an permied address for the
server.
If mulple registers were requested, at least one was not permied.
Reference: MODBUS Applicaon Protocol Specicaon V1.1b3, April 26 2012
For more informaon refer to the Modbus organisaon website.
14.5. ASCII Table
Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial Modus Excepon Codes
Page 132 of 133 SCM-1202-152 Version 1.12