Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
7-pin connector Pin Signal
1 +5 V OUT
2 RS485+ A
3 RS485- B
4 Signal GND
5 Funconal Earth (FE)
6 RS232 Tx Transmit Data
7 RS232 Rx Receive Data
2. Connect the 7-pin connector to the Communicator.
3. Connect the Communicator to your serial subnetwork.
To Do Next
Connect the Communicator to the EtherNet/IP network and to power.
Check LED status, refer to Communicator LED Indicators (page 94).
Connect to Serial RS232/RS485 Subnetwork Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial
SCM-1202-152 Version 1.12 Page 17 of 133