Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
6. Conguraon Quick Guide
This secon is intended to give you a short overview of the tasks you need to perform to congure the
Communicator.
For detailed informaon, please refer to Communicator Conguraon (page 34) .
6.1. Prepare Conguraon
1. Connect Communicator to the EtherNet/IP network.
2. Connect the Communicator to the serial RS232/RS485 subnetwork
Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial Conguraon Quick Guide
Page 24 of 133 SCM-1202-152 Version 1.12