Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
4. Find the Communicator on your PC
The Communicator default IP address is 192.168.0.10.
Opon 1 Opon 2
On the PC accessing the Communicator built-in web interface,
set a stac IP address within the same IP address range as the
Communicator IP address.
Change the IP address on the Communicator conguraon port to
one within the same IP address range as your PC.
Use the soware applicaon HMS IPcong to nd the
Communicator default IP address on your PC.
Download the installaon les and user documentaon from
www.anybus.com/support.
5. Access the Communicator built-in web interface
Open the Communicator built-in web interface in HMS IPcong or enter the Communicator IP address in
your web browser.
The Communicator built-in web interface overview page opens in your browser.
Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial Prepare Conguraon
Page 26 of 133 SCM-1202-152 Version 1.12