Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
3. Add Nodes and Transacons
On the Nodes & transacons page:
a. Add a node and congure the node sengs.
b. Add commands to the node and congure the command sengs.
c. Repeat unl you have added and congured all your nodes.
4. High level network conguraon
On the EtherNet/IP page:
1. Use Automac I/O sizes provided by the subnetwork or choose to set them manually.
2. Enable DHCP server or choose to set a specic IP address.
Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial Setup New Conguraon
Page 28 of 133 SCM-1202-152 Version 1.12