Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
7.7.2. Add Frame Fields
Procedure
1. In the transacon template list, select a transacon template to add frame elds to.
Figure 32. Select
transacon template
2. Build the transacons.
• To add frame elds: In the Frame editor frame elds menu, drag and drop the desired frame elds into the
drag and drop elds.
Figure 33. Add frame elds
• To duplicate a frame eld: On the frame eld that you want to duplicate, click the three dots icon and then
click Duplicate.
Figure 34. Duplicate frame elds
Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial Build Transacon Template
Page 52 of 133 SCM-1202-152 Version 1.12