Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
7.8.6. Acvate/Deacvate Transacon
Figure 51. Acvate/Deacvate Transacon
The transacon default status is Acve.
To deacvate/acvate a transacon, select the transacon and click the slide toggle.
7.8.7. Duplicate Transacon
When you duplicate a transacon, all sengs are preserved.
Figure 52. Duplicate transacon
To duplicate:
• One transacon, select the command and click Duplicate.
• Mulple transacons, select the checkbox in front of each transacon you want to duplicate and click
Duplicate.
The duplicated transacon is added at the boom of the transacons list.
Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial Nodes and Transacons
Page 68 of 133 SCM-1202-152 Version 1.12