Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
7.9.4. To Congure IP Sengs Manually
Figure 57. IP Sengs, DCHP disabled
1. Deselect the DHCP enabled checkbox.
2. Congure the IP sengs.
Seng Descripon
IP address The EtherNet/IP network IP address in IPv4 dot-decimal notaon
Subnet mask The EtherNet/IP network Subnet mask in IPv4 dot-decimal notaon.
Gateway address The EtherNet/IP network Gateway address in IPv4 dot-decimal notaon.
If there is no gateway available, set the Gateway address to: 0.0.0.0
Primary DNS The EtherNet/IP network Primary DNS in IPv4 dot-decimal notaon.
Secondary DNS The EtherNet/IP network Secondary DNS in IPv4 dot-decimal notaon.
Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial High Level Network Sengs
Page 72 of 133 SCM-1202-152 Version 1.12