Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
7.10. I/O Data Map
Figure 60. I/O data map page
On the I/O data map page the data communicaon between the subnetwork (Node) and the high level network
(PLC) is mapped.
The allocated I/O area is auto-generated based on how the sengs on the Serial communicaon page and the
Nodes and transacons page are congured.
It is possible to set the I/O area manually, if you want to pro-acvely allocate more I/O for future expansions
without re-conguring the PLC. See To Congure I/O Sizes Manually (page 70).
There are three areas: Data from EtherNet/IP, Data to EtherNet/IP and General area. See Map Area (page 77).
Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial I/O Data Map
Page 74 of 133 SCM-1202-152 Version 1.12