Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
3. In the Open dialog box, browse to and select the conguraon .cfg le and click Open.
4. If you want to import a name le, click Select name le (.cfx).
5. In the Open dialog box, browse to and select the conguraon .cfx le and click Open.
6. To import the conguraon, click Import.
Figure 78. Example, selected .cfg and .cfx les
Result
The Communicator Classic serial conguraon sengs are imported.
A window with messages about the imported conguraon appear.
In the list you can view the sengs that are fully supported or adjusted to work with Communicator and which
sengs that are not supported and must be set manually in the built-in Communicator interface.
To export the messages in an Excel XLS le, click Export Messages.
To apply the sengs, click Apply in the web-interface header, and follow the instrucons.
Figure 79. Example, list with messages about the import
To Use an Communicator Classic Conguraon Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial
SCM-1202-152 Version 1.12 Page 89 of 133