Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
8. PLC Conguraon
8.1. Export I/O Data Map
When conguring the communicaon between the PLC and the nodes on the subnetwork, use the I/O data map
as a specicaon to ensure that the transacons match.
Figure 80. I/O data map page
On the I/O data map page you can export the I/O data map in an Excel XLS le, where all the nodes and
transacons are listed.
To export the I/O data map:
1. Click Export.
An Excel XLS le with the mapping is downloaded to your PC.
8.2. Export Product EDS File
Opon if the PLC program requires a product le, EDS (Electronic Data Sheet) le, describing how the
Communicator can be used on the high level network.
Figure 81. Export Product EDS File
You nd the EtherNet/IP™ EDS le on the Communicator built-in web interface EtherNet/IP™ page, Files &
rmware page and on the Support page.
To export the EDS le:
1. Click EDS le.
The EDS le is downloaded to your PC.
Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial PLC Conguraon
Page 90 of 133 SCM-1202-152 Version 1.12