Manual
Table Of Contents
- Anybus® Communicator™ - EtherNet/IP™ to Modbus RTU/Serial
- Table of Contents
- 1. Preface
- 2. Safety
- 3. Preparation
- 4. About Anybus Communicator
- 5. Installation
- 6. Configuration Quick Guide
- 7. Communicator Configuration
- 7.1. Connect the Communicator
- 7.2. Access the Built-In Web Interface From HMS IPconfig
- 7.3. Access the Built-In Web Interface From a Web Browser
- 7.4. Communicator Built-In Web Interface Overview
- 7.5. General Subnetwork Settings
- 7.6. About Transaction Templates
- 7.7. Build Transaction Template
- 7.8. Nodes and Transactions
- 7.9. High Level Network Settings
- 7.10. I/O Data Map
- 7.11. Configuration Notes
- 7.12. Apply Configuration
- 7.13. To Use an Existing Configuration
- 7.14. To Use an Communicator Classic Configuration
- 8. PLC Configuration
- 9. Verify Operation
- 10. Use Cases
- 11. Maintenance
- 12. Troubleshooting
- 13. Technical Data
- 14. Reference Guides
9. Verify Operaon
Before You Begin
Ensure that the Communicator is connected to your PC, to a power supply and to the OT network.
See Installaon (page 13).
9.1. Communicator Status Monitor
On the Home page, you can get a quick overview of the network and the Communicator operang status.
Figure 82. Home page
Gateway Status
Overview the Communicator LED indicaons remotely.
Refer to Communicator LED Indicators (page 94).
Node Status
Overview the status for each node added to the subnetwork.
Network Status and Sengs
Overview communicaon status and the current networks sengs.
Anybus
®
Communicator
™
- EtherNet/IP
™
to Modbus RTU/Serial Verify Operaon
Page 92 of 133 SCM-1202-152 Version 1.12