Instructions
Table Of Contents
- 1 Preface
- 2 Description
- 3 Installation
- 4 Configuration
- 4.1 General
- 4.2 Web Interface
- 4.2.1 System Overview
- 4.2.2 Easy Config
- 4.2.3 Network Settings
- 4.2.4 WLAN Settings - Client
- 4.2.5 WLAN Settings - Access Point
- 4.2.6 Bluetooth Settings – General
- 4.2.7 Bluetooth Settings – PANU Mode
- 4.2.8 Bluetooth Settings – NAP Mode
- 4.2.9 Bluetooth LE Settings
- 4.2.10 Firmware Update
- 4.2.11 AT Commands
- 4.2.12 System Settings
- 4.3 Factory Restore
- A Configuration Examples
- B Wireless Technology Basics
- C Technical Data
Appendix A: Configuration Examples 29 (40)
A Configuration Examples
A.1 Ethernet Bridge via WLAN or Bluetooth
®
Configuration with Easy Config
Fig. 19 Ethernet bridge
This example describes how to connect two Ethernet network segments via WLAN or Bluetooth
using Easy Config.
1. In the web interface of unit 1, activate Easy Config Mode 4. This unit will now be
discoverable and open for automatic configuration.
Fig. 20 Easy Config Mode 4
2. In the web interface of unit 2, activate Easy Config Mode 5 for WLAN or 6 for Bluetooth.
This unit should now automatically discover and configure unit 1 as a client, and configure
itself as an access point.
Fig. 21 Easy Config Mode 5
Unit 1 will automatically be assigned the first free IP address within the same Ethernet
subnet as unit 2.
Adding More Devices
Up to 6 additional clients can be added by repeating the procedure. Each new client will be
assigned the next free IP address within the current subnet.
Anybus
®
Wireless Bolt
™
User Manual
SCM-1202-007 2.6 en-US